Radar Line V Carving Beauty Machine for Wrinkle Removal
|Album||View larger image|
|Model||AM-Radar line carving|
|Power supply voltage||90-220V|
|Instrument size||4.2 * 4 * 17cm|
|FOB port||EXW BEIJING|
|Terms of Payment||Western Union, T/T, Paypal|
Portable Radio Frequency Radar Line V Carving Beauty Machine for Wrinkle Removal
Facial Lift: Reshapes the contours and tightens the entire face, including the eyes, cheeks, forehead and neck, for a comprehensive improvement of facial contours
Firming skin: stimulates collagen regeneration in the body, increases collagen content in the skin, and enhances skin elasticity
Remove wrinkles: Remove crow's feet, forehead lines, wrinkles between the eyebrows, and lip contours to smooth out the skin.
Promotes metabolism: stimulates the spontaneous proliferation and reorganization of elastic fibers, reversing the process of aging of collagen cells.
wrinkle removal beauty device Operation Steps:
1.Firsly , you need to clean the treatment area(If it has make up , you need to remove make up then using cleanser to clean the area)
2. Connect the power line , Press the round button to turn on the machine(There has a large round button on each side of the button, press any one of them can turn on the machine , press it when the light turn to light , the machine is on , if you need to turn off the machine , press the button to 1.5 seconds
3.The depths and energy of the machine can be adjusted when the machine turns on, We suggest 4.5mm to operating on face
4.The energy of the Ultrasound and RF have 3 levels: Low , Medium , High. The round button on the handle can adjust the power of the RF. The reverse button can adjust the power of the Mechanical wave. The round button below are the Operation button/ pause button. Press the operation button , will have 30 seconds automatic output, During the output , all the button are unavailable ,and the buzzer will sound once every second. If it doesn’t sound , it means it has finished the 30 seconds output. If pause needed during the period of output, press the pause button. The square push button can adjust the depth. There are 3.0mm/4.5mm respectively , the red line is corresponds to the depth
5.Testing the energy intensity: First pull up from the right lower jaw to the top of mouth in a stable speed, If you feel nothing , you can adjust the energy of Mechanical wave and RF, It is normal that you feel heat , tingling or sore. When operating to the wing of the nose , the energy need to be lower.(Different treatment area can bear different energy , You need to adjust the energy according to the customer’s tolerance )
Normal Skin: For the first time using Mechanical wave and RF , Needs to start from the lowest intensity, And can adjust the intensity according to the maximum tolerance during the treatment.
Red bloody skin: For the first use , we suggest only turn on Mechanical wave. After using 3-4 times , you can turn on the RF with the Mechanical wave at the same time, RF energy start from the lowest intensity, and adjust the power of Mechanical wave according to your maximum tolerance .
Sensitive cuticle slants thin skin: For the fist use, Lowest power of Mechanical wave and RF are suggested, After using 2-3 times , Can adjust the energy to your maximum tolerance according to personal skin situation.
6.During the treatment ,it is necessary to apply the medium on the treatment area, the cartridge needs to closed to the skin , with regular speed and lifting method, the medium needs to be supplied when it is absorbed or dried.
7.Usually it takes 30-45 minutes for one operation of the whole face.(The operating time changes according to the size of face. )
8.Cleaning the cartridge with wet towel is needed after the operation.
9.After the operation , do clean the face with warm water or Clear water, apply one moisturizing mask right after the operation. about 10~15 minutes is ok , if the moisture has been absorbed or dried , you need to supply it (hot water not suggested)